Side Dump/Spreader Box:
The spreader/side unloader utilizes a
manure spreader design and a side dump design into one machine,
eliminating the need to buy separate equipment to do the same operation our machine can. This is a huge money saver compared to purchasing a side dump trailer and truck to stock pile and a manure spreader to complete the task of spreading. Can also be built as a pull type box without being mounted to a truck.
The distributors hydraulically fold out away from the bed and are self locking and unlocking. Each rotator is driven by separate hydraulic motors. The spread pattern is between 26’ and 30’ wide depending on consistency of the material while requiring less horsepower than most other horizontal distributors. The distributor can be taken off by removing 2 pins and the 6 quick disconnect
hydraulic fittings. Each rotator slides out the back of the housing for easy
removal if only one rotator is needed, such as spreading large frozen chunks.
The silage sides detach by removing 2 pines and lifting straight up. The river’s side rotates on top to allow the door to swing upward from the force of the
material falling out while the passenger side is mounted solid. The side wall of the spreader box locks and unlocks this in place.
Floor / End Gate
The floor has 1/2” UHMW plastic and 3 sets of pintle chains (6 chains total) and is reversible to unclog the distributors if they were to stall. Each set of chains is
tightened by one set bolt under the bed to allow easy access for adjustment. The end gate lifts straight up to allow more bed space to be used out the total length of the box. It is synchronized with the floor chain motors to ensure the gate will be up before the load be pushed.